Scion iM Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 · (Edited)
I finally finished wiring an iDataLink Maestro RR to a Pioneer AVH-4200NEX for my 2016 Scion iM. Everything but the backup camera works. I already knew this was gonna happen because it was mentioned on the forum that I would need an AX-TOYCAM3 harness to retain my factory camera.

I purchased this one on ebay:
https://www.ebay.com/itm/362428858704

I have the harness now but I have no idea how to wire it. It comes with a stripped yellow and black wire, and a male and female rca plug (see attached image).

How do I integrate this harness with my idatalink maestro/4200NEX setup?
What do I do about the reverse gear signal, or is it already included in the camera harness?
Do I have to worry about the oem camera voltage?
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top