Scion iM Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
432 Posts
Found on CarID dot com.

Has anyone used these?
When posting something like this it helps to post a link or picture. ;)
 

·
Registered
Joined
·
432 Posts
I suspect, that like me, they haven't been a member long enough to post a link or upload a picture...
I see that your are from Stillwater, OK. I was born there! I never lived there but my my mom was at my grandparents when I decided to make my appearance. Both of my grandparents worked at OSU.
 

·
Registered
Joined
·
73 Posts
I see that your are from Stillwater, OK. I was born there! I never lived there but my my mom was at my grandparents when I decided to make my appearance. Both of my grandparents worked at OSU.
Small world. Been here since '93, seen things change a lot over the years
 

·
Registered
Joined
·
432 Posts
Small world. Been here since '93, seen things change a lot over the years
That's about the last time I was there. I think that's the year my grandpa passed away and I was there for the funeral. Haven't had a reason to go back with no family there now.
 

·
Registered
Joined
·
73 Posts
I have a set, but have not had time to put them in yet. The quality of them looks good, but the ones I have didn't come with really any instructions. However there are posts on here from where other folks have installed them and give suggestions on how to hook up the wiring.
 

·
Registered
Joined
·
47 Posts
Discussion Starter · #9 ·
I have a set, but have not had time to put them in yet. The quality of them looks good, but the ones I have didn't come with really any instructions. However there are posts on here from where other folks have installed them and give suggestions on how to hook up the wiring.
so you have the winjet ones???

I have a MDT (master diag tech) from toyota to help me install them. So no issues there. He is an electrical god, and have good faith in his install. Just need to make sure it comes with everything he will need. Have you compared them to the stock fascia area where the foglights should be? Do the housings look identical? Same glossy finish?
 

·
Registered
Joined
·
73 Posts
The box says WinJet on it. I looked through everything when I got them, and looked complete to me.

The housings have the same finish, look like they should fit no problem.

Only difference I've seen, where the stock fascia has a blank behind the mesh, these do not - so you can see through them. Was going to see if I can transfer the existing ones over (with some mods to fit around the light).
 

·
Registered
Joined
·
47 Posts
Discussion Starter · #11 ·
So i am getting ready to order these, carid has a HID upgrade but its quite costly. Does anyone have HID fogs?
 

·
Registered
Joined
·
432 Posts
So i am getting ready to order these, carid has a HID upgrade but its quite costly. Does anyone have HID fogs?
I've seen it said many times to never use HID bulbs for fog lights. The results aren't very good from what people have said.
 

·
Registered
Joined
·
47 Posts
Discussion Starter · #13 ·
Yea that's what I've been reading.

Going to order just the normal fog light kit, and will post pictures and thoughts after.
 
1 - 13 of 13 Posts
Top