Scion iM Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hey hey,

I recently bought bought the traction bar and was wondering if anyone else has it and installed it yet. Trying to figure out where it goes.
 

·
Registered
Joined
·
1,288 Posts
Not sure what purpose a traction bar would be on the iM, but they typically run from mid chassis towards the rear axle.

Don't think I recall anyone here installing them. Message the seller for further directions.
 

·
Registered
Joined
·
1 Posts
I think theres a thread on here already about it, I've never called it a traction bar, normally I would say strut brace or bar.
 

·
Registered
Joined
·
432 Posts
Hey hey,

I recently bought bought the traction bar and was wondering if anyone else has it and installed it yet. Trying to figure out where it goes.
The traction bar is designed to help with torque steer and wheel hop so it should be obvious as to where it gets mounted once you look under the car. Should be up front toward the engine/trans position and just back from there.
 
1 - 6 of 6 Posts
Top