Scion iM Forum banner

My exhaust setup with Magnaflow 10416 and straight pipe

5285 Views 5 Replies 4 Participants Last post by  Ochoa365
2
Hey guys,

Just thought I'd share my exhaust set up with you. I've played around with it a little bit and this is the one I think sounds the best, inside and out. Not as loud from the inside though. The setup is with a Magnaflow 10416 Satin Stainless Steel 2.5in Round Muffler (where the freeway drone used to be), stock muffler (2nd to last going from front to back of the car), and a straight pipe with the stock tip at the end of it. Hope this helps anybody who needs any info. I can take more sound videos if requested. This one is only from inside the car.




View My Video

Attachments

See less See more
  • Like
Reactions: 1
1 - 6 of 6 Posts
I'm struggling with that link.. I can't see anything for some reason =[ The welding looks pretty decent though :)
wow that sounds great, i'd love to hear that from my car. so the only thin you did was replace the stock muffler with a straight pipe?
mobile

I'm struggling with that link.. I can't see anything for some reason =[ The welding looks pretty decent though :)
I could not see it on my mobile device, but works fine on my laptop
I could not see it on my mobile device, but works fine on my laptop
Ahh I tried opening it with FireFox and it didn't work. Used chrome and all was well. Thanks !


It does sound pretty nice though, a nice deeper tone rather than a ricey high pitched noise
wow that sounds great, i'd love to hear that from my car. so the only thin you did was replace the stock muffler with a straight pipe?
Yes the muffler right before the tip. And the Magnaflow resonator went towards the front of the car right before the engine. I'd recommend welding any tip onto the pipe though. Looks good. I realized how much torque I was missing when I got the straight pipe installed because I used to have a 4 inch big bore exhaust muffler and could feel the difference right after take off from a stop.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top