Scion iM Forum banner
1 - 15 of 15 Posts

· Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
Hello .... new to the forum but been lurking for some time now. Waited for something worth contributing.

XXR 557 18 X 8.5 ET 35 all around with centric hub ring
Hankook Ventus V12 Evo2
Front: 225/40R18
Rear: 255/35R18
Muteki lugs

H&R springs are sitting in the trunk waiting to be installed.

Red pin stripe accent on front lip. Similar material used on motorcycle rims.
Red accent painted lower valence
3M Di-Noc Carbon Fiber Vinyl lower rear door

Curt tow hitch

Enjoy! Welcome any feedback. :)
 

Attachments

· Registered
Joined
·
120 Posts
Like the Red Accent...just dont go too crazy w/ adding color red accents everywhere if you plan on adding more!

Planning to get the H&R Lowering Springs too!....Give an update how they feel & ride!
 

· Registered
Joined
·
12 Posts
No fitment/rubbing issues even after H&R springs were installed and settled. Not even over bumps or hard cornering with the car fully loaded with people.

thanks for the feedback. your car looks so f'ing sick.
are the pics shown in the 1st post lowered or not lowered? i actually like the ride height in the pics on the 1st post.
 

· Registered
Joined
·
20 Posts
Discussion Starter · #12 ·
Updated Pics

Finally got around to it but here are updated pics with following changes:

1. H&R Springs installed and settled
2. Fogs with yellow film
3. Removed front red pin stripe and use Plexi Dip (red). Looks good from afar but close up doesn't meet my standard. Still debating whether I should leave it or remove it.

Enjoy!

Wheel Tire Car Vehicle Automotive tire


Wheel Car Tire Land vehicle Vehicle


Tire Vehicle registration plate Vehicle Car Wheel


Wheel Tire Car Vehicle Automotive lighting
 

· Registered
Joined
·
1,303 Posts
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top