Scion iM Forum banner

Bras Covers and Deflectors

5803 Views 7 Replies 4 Participants Last post by  davect01
Due to my road conditions and getting some chips on the leading edge of my hood I bought the Magnetbra. Easy to install. Only issue is the U channel seal is special and it is reinforced with 3 metal strips and trying to trim it became a challenge bending inside the seal since it was about 2 inches too long. Cut it with something very sharp. I didn't know it was in there till I cut it. Fill the ends with black silicone. It would be nicer if the seal was smooth. Sorry bad picture have to take another.

Magnetic car bras, auto hood bra, nose mask for your car, truck or SUV :: Home

Attachments

See less See more
1 - 8 of 8 Posts
I've always seen these and was always worried they wouldn't be secure enough and fall off or something. Have you had experience with these front end bras before ?
Magnetbra

I've always seen these and was always worried they wouldn't be secure enough and fall off or something. Have you had experience with these front end bras before ?

Nope no experience. It is not going to come off. I drive 40 miles each way daily in heavy traffic and most of it a 80 mph. I'm happy with it so far.
  • Like
Reactions: 1
i'm gonna get this and stick it on. get some knifeless tape if you'll do something like this, makes it a million times easier to cut it correctly since you don't have to precut and don't have to use a blade on the car.
24"X60" Clear Bra Paint Protection Vinyl Film Wrap Transparent Car Paint Shield | eBay
A better picture. So far so good no issues. Check my Garage pictures for a side view.

Attachments

See less See more
A better picture. So far so good no issues. Check my Garage pictures for a side view.
Seriously considering
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top